Airsoft Picatanny Rails Work on Real Guns

Airsoft guns differ from real guns, so following that logic, the airsoft accessories should not fit on the real guns and vice versa. However, this is not exactly true, at least not for all accessories.

I accept compared the "real" gear and the one that tin be found in airsoft stores and shops and I have found what parts tin can exist used on both, the real guns and replicas just every bit which accessories are simply not plumbing equipment well at all.

So, what would the short answer wait like, can the airsoft accessories be used on real guns and vice versa?

Inner parts only exercise not part, merely some airsoft accessories like Flashlights, red dots, barrel clamps and holsters tin can be used on real guns too, however this depends on the quality of the manufacturer. Many parts and accessories are likewise poorly designed and will be hardly usable on anything with real recoil.

We are all enlightened that you lot can discover airsoft accessories such equally optics at very depression prices such as $30, the real counterpart would certainly cost at to the lowest degree $300 and this is a expert introduction to let you know that at that place might be major differences that may not be seen at first sight.

We will go through all available accessories and parts and say a few words about them, but allow'southward first mention that no airsoft inner parts will ever work on real guns and vice versa.

Therefore, we will merely mention the outer parts and surprisingly some work quite well in both cases.

It is also a rule of thumb that real gun accessories perform better and are more probable to find the purpose in airsoft world, while the airsoft accessories often lack the quality that would be required to sustain the purpose on real guns, peculiarly if the real guns are used for existent life applicable scenarios.

Can you lot catechumen airsoft gun into a real gun?

There are some parts like the lower gun receiver that forms the body of a gun and in some cases the airsoft gun receivers tin can seem equally a great option.

At the showtime expect information technology has everything and information technology seems that everything will fit in it, notwithstanding likewise the possible quality metal build, it can hardly fit the real gun inner parts.

The virtually common problem is to fit real gun parts within the frame because nearly parts of the airsoft gun are designed to fit smaller parts and machinery, subsequently all a BB differs from a bullet past far.

Technically speaking, information technology is possible to adjust the sizes and fit those existent gun parts in, only it would require tremendous corporeality of work with various tools and great agreement of the matter.

Yous would too need to have an admission to all those real gun parts and information technology is easier to buy a gun illegally if someone desires to break the constabulary anyways.

In any case, information technology but is not worth information technology and nosotros would end up with a conclusion that it is easier to create an improvised gun from bones metal tubes and other affordable parts that with proper engineering tin become an effective weapon.

This is as well a reason why there is no need to worry that airsoft guns tin can be easily transformed into real guns and exist used for illegal activities.

All the same, some states have constructed the police force against airsoft guns exactly because of this irrational fear.

Flashlights and red dots are always useful

At that place is not much to say regarding flashlights and red dots because they exercise not differ in whatsoever manner other than the quality.

There are many flashlights and red dots on the marketplace and some are better and some are worse, quite simple.

No matter which one we take as an example, every single one volition be usable on both real guns and airsoft guns and the quality of operation is the only real factor.

However, flashlights and crimson dots need something to be fastened to and it leads us to the next parts we are going to hash out.

Gun Rails and Barrel clamps

Without these parts you can not attach annihilation onto your gun, whether it is the airsoft or a real one.

Airsoft rail and barrel clamps differ in quality from their real counterparts and therefore it is non suggested to employ such airsoft parts on existent guns, but the real rails and clamps tin exist used on airsoft replicas.

The reason behind this is that such airsoft parts often lack the stiffness that is required for the optimal precision when exposed to the existent recoil.

Simply, the depression quality and cheaper airsoft parts can non sustain the gun recoil and will simply give upwardly at a certain time. The same tin be said well-nigh the oestrus, the airsoft rails are more likely to melt.

The real gun rails and barrel clamps are manner more expensive and are treated equally important gun parts, therefore it would make more logic to put them on airsoft guns if yous accept the admission to them and if they fit the model, but what is the purpose of that? It won't give you an edge.

Paw guards, Rail covers and protectors

We must mention hand guards, rail covers and protectors considering they are very mutual parts on guns, especially on real guns.

The matter with these is that the airsoft replicas have a problem with sustaining the heat and are very likely to break under the recoil.

Using such existent parts on airsoft guns are again, adequate, but there is no point in doing that.

Scopes

Having a real, high-cease scope on the airsoft gun is a wonderful thing, in other way around, not so much.

Scopes are extremely dependent on the tier and probably any airsoft scope won't be able to sustain the heavy recoil on the guns. The other problem is accuracy on long distances, airsoft replicas just are not built for this.

In other manus, in that location are players who adhere the real high-tier on their snipers and study that they piece of work slap-up. I hateful, it probably might give you an edge because the quality difference is unquestionable, but the price difference in unquestionable too.

Grips and stocks

Grips and stocks greatly depend on a model of a gun, but often tin can be used vice versa.

I don't know much about grips and how often would they fit in majority of guns, only I practice know that there are some realistic 1:one airsoft replicas that are identical to their counterparts and certainly grips fit them.

This is a wide question because once more, the exact model is required, but some models definitely fit grips, so if you have a gun, miss a grip and want to find a cheap option, you can look for airsoft grips and try them out if they fit.

We may assume that the quality is worse on replicated grips, but I practice not think that it is the case. Colt 1991 is known for having a polymer grip and the airsoft replicas oftentimes utilize the similar high-quality polymer in manufacturing likewise.

The same goes for stocks, if they fit, they can be used. However, even though I accept heard that people use replica stocks on their rifles, I wonder how long they last.

I mean, I am kind of skeptical that the recoil won't destroy them after some time because I dubiousness that the manufacturers thought almost real recoil when they designed these.

Holsters and Slings

There are many different models of magazine and gun holsters and some will fit both existent magazines and guns just every bit they will fit the replicated ones.

For instance, there is an airsoft gun holster for Glock licensed replica G19 that will also fit the G17.

Not all gun replicas are exactly the aforementioned in dimensions, only some conspicuously are.

Slings can besides fit both guns and are pretty much universal, however in that location is a full general thought that the airsoft slings oft lack quality, only information technology does not have to exist true.

Burglarize rest

There is no word here, I have not seen a single airsoft rifle rest that I would comfortably use with a existent rifle yet.

These polymer, non-loyal replicated burglarize rests would probably break at very starting time occasion, especially if we talk near some powerful rifles such as AR-50.

Just avert them.

A good way to go around legal issues

I accept heard stories where people with real rifles missed a stock and decided to become the high-quality airsoft replicated one instead of a real ane in gild to avoid the legalities.

Very ofttimes when ownership the real gun parts, you also need to go through a legal procedure before yous tin become the desired parts.

This can be skipped if yous decide to use the airsoft replicated parts instead, however only a few parts are worth getting this way, perhaps the stocks are ane of them.

Determination

Well, we have found out that at that place is not much of a practical apply of these parts betwixt existent guns and their replicas at all.

In some cases you may save some budget or skip the legal norms, just at the end, in most cases it does not actually matter.

This is likewise a practiced mode to understand that airsoft replicas are non really dangerous and are most incommunicable to exist converted into real guns.

Some aesthetic and functional parts are bachelor, but none will ever increase the lethality of a gun in whatever example.

Recommended books to skyrocket your airsoft experience and skills

The first book of the airsoft bible teaches you adapted tactics that piece of work within the field which are based on real military tactics.

The 2nd book will teach you lot and your team about the essential skill of communication (necessary for team synergy and this is exactly what separates great teams from average).

Search This Blog

Ellwood Critheryou